Nimbus M NET R32 Range (User Manual) EU

User

User Menu SCOP Shows the estimate of the seasonal COP estimate of the heat pump (only for configured devices). SEER Shows the estimate of the seasonal EER estimate of the heat pump (only for configured devices). CO2 SAVED Shows the estimate of the kilograms of CO2 saved with the thermal production of the solar heating system. SHOWERS N° Shows the estimate of remaining showers (if a solar heating controller or a DHW heat pump is installed). REPORT RESET Resets the data appearing in the system performance pages. 3.9 Diagnostics Diagnostics Boiler > Energy Manager > Heat Pump TDM > Solar Controller > 3.10 Screen settings 3.10.1 Language Screen settings Language English Time & Date > Home screen > Screen brightness 50% Standby settings > Fig. 57 – Turn the selector to highlight the “Language” item – Press the selector to enter the edit mode. – Turn the selector to choose the desired language. – Press the selector to confirm. 3.10.2 Time & Date Time & Date Date 30 / 05 / 2021 Fig. 55 The diagnostics page shows the main operating parameters of the devices present in the system. Time 15 : 20 Legal hour Save Auto Boiler CH flow set T 55°C CH flow temperature 20°C CH return temperature 20°C Fig. 58 – Turn the selector to change the value of the selected field. – Press the selector to skip to the next item. – To change a previously set value, press the “Back” button . 3.10.3 Home screen Fig. 56 From this menu you can set the type of home page. – Press the selector to enter the edit mode. – Turn the selector to choose one of the available settings: “Complete”, “Base”, “Customizable” and “Hp Water Heater”. 22 / EN

User Menu 3.10.4 Screen brightness From this menu you can change the brightness of the display. – Press the selector to enter the edit mode. – Turn the selector to adjust the brightness of the display when it is in active mode (from 10% to 100%). – Press the selector to confirm. 3.10.5 Standby settings Standby settings Brightness in standby 70% Standby timing Screen saver selection 1 min Room T Fig. 59 – "Brightness in standby": allows to set the brightness of the display when the device is in stand-by mode (from 10% to 30%). – "Standby timing": allows to set the time interval (from 1 to 10 minutes) from the last operation made on the device, after which the screen enters stand-by mode and its brightness is reduced to the value set for the stand-by mode. – "Screen saver selection": allows to select the type of screen to be displayed in stand-by mode. 3.11 Advanced settings 3.11.1 CH settings Advanced settings CH settings > Cooling settings > AUTO function ON Buffer > Heat Pump > System measurement unit International system Fig. 61 – "CH setpoint temperature": in the menu you can set the water temperature set-point in heating mode for each hydraulic zone present in the system. The menu can be used to: – adjust the temperature set-point if the automatic temperature control function (“AUTO function”) is disabled. – apply a correction to the temperature set-point using a slider, if the automatic temperature control function (“AUTO function”) is active and the water temperature does not match the desired temperature. T set Z1 Standby settings Brightness in standby 70% OFF Standby timing Room 1 minT Screen saver selection - 0°C + Push Ok to confirm Fig. 62 Fig. 60 – "OFF": displays the selected home page. – "Room T": displays the current room temperature. 23 / EN