Nimbus M NET R32 Range (User Manual) EU

User

User Menu 3.6.1 Thermal cleanse function 3.7 Connectivity Thermal cleanse function Thermal cleanse function OFF Thermal Cleanse Cycle frequency 30 days Thermal Cleanse start time [hh:mm] 01:00 Connectivity ON/OFF Wi-Fi Network ON Network configuration > Serial number > Reconfiguration > Signal Level 0% Internet Time ON a Fig. 47 – "Thermal cleanse function": enables/disables the thermal sanitisation of the DHW cylinder. – “Thermal Cleanse Cycle frequency” (where available): sets the frequency of the sanitisation cycle (24 hours - 30 days). – “Thermal Cleanse start time [hh:mm]” (where available): sets the start time for the thermal sanitisation cycle. If the thermal sanitisation cycle is not completed within the scheduled time, it will be repeated on the following day at the specified time. Fig. 48 – "ON/OFF Wi-Fi Network": Enables/disables the Wi-Fi module connected to the system – "Network configuration": Enables the configuration of the Wi-Fi module present in the system. Read the product instructions for further information. – "Serial number": Displays the serial number of the Wi- Fi device installed. – "Reconfiguration": Restores the factory settings of the Wi-Fi device. – "Signal Level": Displays the Wi-Fi signal strength on a scale from 0 to 100. – "Internet Time": Enables the acquisition of the system’s time from the Internet – "Internet weather": Enables the acquisition of the outdoor temperature and the weather conditions from the Internet 3.8 System info System info SW Version interface 00.03.02 Zone number 1 System Performance > Diagnostics > Fig. 49 3.8.1 SW Version interface Shows the device’s software version. 3.8.2 Zone number Shows the zone associated with the device. 20 / EN

User Menu 3.8.3 System Performance System Performance Energy metering > SCOP 3,5 SEER 3,2 CO2 saved 100kg Showers n° 5 Report Reset > ENERGY CONSUMPTION Energy metering Fig. 50 Consumptions graph > Consumption table > Production graph > Units of measure and costs > Fig. 51 – "Consumptions graph": refer to the paragraph “Consumptions graph”. – "Consumption table": Shows the estimate in numerical format for consumption in heating, cooling and DHW modes. The estimate is calculated based on the selected measurement unit and on consumption information from the current or previous year. – "Production graph": shows through histograms the estimate of the thermal energy produced. The estimate is calculated according to the type of generator present in the system in the heating, DHW and cooling modes. Type kWh 8 6 4 2 0 Time base Tot: 8 kWh TOT CH DHW COOL 1 8 15 22 29 – "Units of measure and costs": Running month Fig. 53 – “Currency”: the parameter sets the currency shown in the consumption charts. – “Gas Type”: selects the type of gas used to calculate the gas consumption estimates. – “Gas units”: selects the unit of measurement used for gas consumption estimates. – “Gas cost”: sets the price for the unit of measurement used to calculate gas consumption estimates. – “Electric units”: selects the unit of measurement for power consumption estimates. – “Electricity cost”: sets the price for the unit of measurement used to calculate power consumption estimates. Units of measure and costs Currency Euro (€) Gas Type NG Gas units kWh Type Gas [kWh] Gas cost 0 cent TOT January 0 0 0 0 February 0 0 0 0 March 0 0 0 0 April 0 0 0 0 Time base Running year Fig. 52 Electric units Electricity cost kWh 0 cent Fig. 54 21 / EN