GB b) Pull mixer lever
GB b) Pull mixer lever (6) upwards to the on position then turn to the right to the hot position. c) Wait until water flows from the sput. d) Push miwer lever (6) downwards to the off position. e) Press the on/off switch (2) and ensure that the heating warning light (1) is on and the on/off light (2) is on. The waterheater Eureka is now ready to use. USER INSTRUCTIONS (Fig. 1) 1. How to turn the water heater on a) Press the on/off switch (2 and check that it is on. b) Check that the heating warning light (1) is on. This light will come on when the hater is in the heating mode. c) When the water in the heater reaches the preset temperature, the thermostat deactivates the heating element automatically and turns off his light. IMPORTANT - This appliance is of the Open Outlet type, therefore, the spout will drip slightly during the heatin mode. 2. How to use the Eureka a) Place mixer lever (6) into the required position. b) Pull lever forward to allow flow of water. c) Adjust temperature of the water by adjusting the position of the lever. IMPORTANT - During the heating mode the tank of the heater will expand. This is due to the elasticity of the materials used in its construction. Maintenance to be carried out by a qualified Technician (Fig. 1) IMPORTANT - Before carrying out any maintenance ensure that you: a) Isolate electricity at mains isolator. b) Turn off water supply to the heater. Access to electrical components (Fig. 3) a) Lift off cover knob A b) Remove screw B c) Remove knob C d) Unscrew retention ring D e) Remove gasket E f) Unscrew safety valve (13) g) Unscrew ring nuts F and remove cover G 25
GB Power cable removal and replacement a) Remove cover (G) as previously described b) Disconnect the live neutral and earth connections c) Remove cable by pulling it through its retaining grommet at the rear of the heater d) Replace cable in reverse oder Replacement of Thermostat a) Remove cover (G) b) Disconnect terminals N and O c) Pull thermostat downwards and remove d) Reassemble in reverse order Replacement of Element a) Remove thermostat b) Unscrew ring nut H and disconnect flange unit L c) Remove screw U d) Remove element by gently pulling away from the flange e) Reassemble in reverse order To ensure the proper performance of our appliance descale the heating element 5 (fig. 3) at least once every two years. Carefully break away the scale without damaging the plating of the heating element. Safety cut-out rese: (Fig. 5) When there is an anomaly in heating the water, a (CEI-EN approved) safety cutout, will cut the circuit out on both poles to the heating element. In order to reactivate the water heater from the mains power supply (11) and let the water cool down. Once the water is cold take out screw (15) and cover (14) using a Philips Screwdriver and apply pressure on point (16) of the thermostat until a click sound is heard. Close the cover (14) with screws (15), connect the water heater to power supply and (11), push the button (2). Be sure power supply is on (1) (Fig. 1). Regulating water temperature The Thermostat is factory set at its maximum. Water outlet temperature is regulated by adjusting the mixer lever. The lever is marked with indicators showing which direction either increases or decreases the temperature. TROUBLE SHOOTING No hot water supply from the spout 26
X