Views
9 months ago

Cube RF - Manual - Ariston

  • Text
  • Instructions
  • Boiler
  • Thermostat
  • Control
  • Cube
  • Heating
  • Manual
  • Technical
  • Ariston
  • Sensor

manual operation

manual operation Manual operation heats or cools the zone in which the room sensor is installed, and maintains the manual temperature setting throughout the day (time scheduling is disabled). Press the "MODE" button until the display shows “ ” (Fig. 4). Modifying the room temperature In manual mode, the set-point temperature (default value 20°C) can be modified. Press the temperature adjustment keys “+” and “-” to set the room temperature (Fig. 5). Press “OK” to confirm. The set value will flash on the display for a few seconds, after which the display will once again show the detected room temperature. Disabling heating/cooling You can disable heating/cooling in the zone in which the room sensor is installed. Press the "MODE" button until the display shows: “ ”. When heating is off, the anti-freeze function is enabled. Anti-freeze function When the anti-freeze function is enabled, the display shows: “ ”. Fig. 4 Fig. 5 In this mode, central heating will only activate if the room temperature falls below 5°C, to protect the pipes against freezing up. Fig. 6 GB - 17

programmed operation Programmed operation is controlled by the heating/cooling schedule set on the system interface. Press the "MODE" button until the display shows “ ” (Fig. 7). Timed adjustment room temperature In programmed mode, you can temporarily modify the set-point temperature set on the system interface. Press the temperature adjustment keys “+” and “-” to set the room temperature (Fig. 8). Press “OK” to confirm the temporary setting. The display will now show “ ” and the time for which the changed setting applies will flash (3h default) (Fig. 9). Press “+” and “-“ to set the duration of the modification, which can vary between 0 hour (minimum) and 24 hours (maximum). Press "OK" to confirm the modified setting. The display will now show the detected room temperature again. When the temporary setting times out, the display will again show the set-point temperature set with the system interface. Fig. 7 Fig. 8 To cancel the modified setting, press “MODE” and select manual mode. Press the "MODE" button until the display shows “ ” to return to programmed operation. Fig. 9 18 - GB