ACTION CONFIGURATION DISPLAY Menu - 5 - Combustion rate control mode (test mode) Effect Display once Combustion rate control mode OFF once Combustion rate control mode ON The main exchanger temperature appears on the display. The digit - on the display shows the gas output level. (Top = max, bottom = min). Gas output setting To modify the gas output use the + and - buttons. x times To cancel the combustion rate control mode press the “Menu” button. The combustion rate control mode will be inactive when : - boiler is in stand-by mode - room thermostat is not calling for heat - boiler in lockout mode - after the default settings have been restored or if the main supply fails (power cut) - if the operator exits the 5th menu - after 5 minutes if no buttons are pressed Note : As soon as the combustion rate control mode is active, the Central Heating and Domestic Hot Water control knobs become inactive. 40
ACTION CONFIGURATION DISPLAY once Menu - 6 - Automatic heating regulation Section Digit 1 Digit 2 Digit 3 and 4 Factory setting Regulation on 6 0 0 : External sensor fitted 1 : External sensor not fitted x times Heating setting in automatic/manual mode 6 1 0 : External sensor not fitted 1 : External sensor fitted Thermal Curve setting (see table D, page 30) 6 2 0.3 0.5 1 1.2 1.5 2 2.5 3 Parallel Shift setting (see table E, page 30) 6 3 from 0 to 20 by steps of 1 In the event of connection of the external sensor, you must: 1. Activate the external sensor (menu 6.0) 2. Activate the external sensor automatic adjustment (menu 6.1) 3. Program the thermal curve (menu 6.2*) 4. Program the parallel shift (menu 6.3*) *SEE SECTIONS 14.7 AND 14.8 (PAGE 31) FOR DETAILED INSTRUCTIONS ON SETTING THE THERMAL CURVE AND PARALLEL SHIFT. 41
ACTION CONFIGURATION DISPLAY Menu - 5 - Combustion rate control mode (test mode) Effect Display once Combustion rate control mode OFF once Combustion rate control mode ON The main exchanger temperature appears on the display. The digit - on the display shows the gas output level. (Top = max, bottom = min). Gas output setting To modify the gas output use the + and - buttons. x times To cancel the combustion rate control mode press the “Menu” button. The combustion rate control mode will be inactive when : - boiler is in stand-by mode - room thermostat is not calling for heat - boiler in lockout mode - after the default settings have been restored or if the main supply fails (power cut) - if the operator exits the 5th menu - after 5 minutes if no buttons are pressed Note : As soon as the combustion rate control mode is active, the Central Heating and Domestic Hot Water control knobs become inactive. 40
ACTION CONFIGURATION DISPLAY once Menu - 6 - Automatic heating regulation Section Digit 1 Digit 2 Digit 3 and 4 Factory setting Regulation on 6 0 0 : External sensor fitted 1 : External sensor not fitted x times Heating setting in automatic/manual mode 6 1 0 : External sensor not fitted 1 : External sensor fitted Thermal Curve setting (see table D, page 30) 6 2 0.3 0.5 1 1.2 1.5 2 2.5 3 Parallel Shift setting (see table E, page 30) 6 3 from 0 to 20 by steps of 1 In the event of connection of the external sensor, you must: 1. Activate the external sensor (menu 6.0) 2. Activate the external sensor automatic adjustment (menu 6.1) 3. Program the thermal curve (menu 6.2*) 4. Program the parallel shift (menu 6.3*) *SEE SECTIONS 14.7 AND 14.8 (PAGE 31) FOR DETAILED INSTRUCTIONS ON SETTING THE THERMAL CURVE AND PARALLEL SHIFT. 41
X