Views
3 years ago

NUOS Plus - Installation Manual

  • Text
  • Appliance
  • Heater
  • Heating
  • Installation
  • Operating
  • Discharge
  • Maintenance
  • Electrical
  • Technical
  • Regulations
  • Nuos

Heat pump water heater

Heat pump water heater – GENERAL INFORMATION 2.5 Technical data table Description Unit of measurement 200D 250I Rated tank capacity l 200 245 Insulation thickness mm ≈ 50 Type of internal tank protection Enamelling Type of corrosion protection Disposable magnesium anode Maximum operating pressure bar 6 Diameter of condensate drainage connection mm 14 Diameter of air exhaust/intake pipes mm 150-160-200 Minimum water hardness °F 12 Minimum conductivity of the water µS/cm 150 Weight when empty kg 90 115 Weight when full kg 290 365 Cylinder (EN 12897:2006) Normal operating pressure bar 3,5 3,5 Maximum water supply pressure bar 12 12 Cold connection (feed) - ¾’’ G ¾’’ G Hot connection (draw off) - ¾’’ G ¾’’ G Pressure Reducing Valve Set Pressure bar 3,5 3,5 Cylinder TPRV °C / bar 90-95 / 7 90-95 / 7 Combination valve PRV bar 6 6 Expansion vessel pre-charge pressure bar 3,5 3,5 Operating temperature of not-resetting thermostat °C - 30-70 Cylinder indirect coil (EN 12897:2006) Connections - - ¾’’ G Surface area m² - 0,65 Maximum supply pressure bar - 6 Rating @60°C l - 181,9 Primary flow rate l/min - 15 Pressure drop through coil @15l/min mbar - 18 Primary heating power input kW - 9,76 Heating time from 15°C to 60°C min - 58:40 Max water temperature with external integration °C - 75 7

Heat pump water heater – GENERAL INFORMATION Heat pump Average electrical power consumption W 700 Max. electrical power consumption W 900 Quantity of R134a refrigerant fluid kg 1,3 Max. pressure of refrigerating circuit (low-pressure side) MPa 1 Max. pressure of refrigerating circuit (high-pressure side) MPa 2,4 Max. water temperature with heat pump ºC 62 EN 16147 COP ( A ) 3,05 3,14 Heating time ( A ) h:min 04:30 05:29 Heating energy consumption ( A ) kWh 2,934 3,718 Max. amount of hot water in a single intake Vmax ( A ), delivered at 55°C l 273 345 Pes ( A ) W 23 24 Tapping ( A ) L XL 812/2013 – 814/2013 ( B ) Qelec ( B ) kWh 3,825 6,066 Ƞwh ( B ) % 126,1 128,5 Mixed water at 40°C V40 ( B ) l 273 345 Temperature setting ( B ) °C 55 55 Annual electricity consuption (average climatic condition) ( B ) kWh/year 812 1303 Load prifile ( B ) L XL Indoor sound power level ( C ) dB(A) 55 55 Heating element Heating element power W 1500+1000 Max. water temperature with heating element ºC 75 Max. current consumption A 11,36 Power supply Voltage / max. power consumption V / W 220-240 single-phase / 2500 Frequency Hz 50 Protection rating Air side Standard air flow rate (automatic modulating control) m 3 /h 650 Available static pressure Pa 110 Minimum volume of room of installation ( D ) m 3 30 Minimum ceiling height of room of installation ( D ) m 1,940 2,200 Min. temperature of room of installation ºC 1 Max. temperature of room of installation ºC 42 Minimum air temperature (w.b. at 90% r.h.) ( E ) ºC -7 Maximum air temperature (w.b. at 90% r.h.) ( E ) ºC 42 (A) Values obtained with external air temperature of 7°C and relative humidity at 87%, inlet water temperature of 10°C and set temperature of 55°C (according to the provisions set forth in EN 16147). Rigid Ø200 ducted product, as per second picture par 4.3. (B) Values obtained with external air temperature of 7°C and relative humidity at 87%, inlet water temperature of 10°C and set temperature of 55°C (according to the provisions set forth in 2014/C 207/03 - transitional methods of measurement and calculation). Rigid Ø200 ducted product, as per second picture par 4.3. (C) Values obtained from average results of three tests carried out with external air temperature of 7°C and relative humidity at 87%, inlet water temperature of 10°C and temperature set according to the provisions set forth in 2014/C 207/03 - transitional methods of measurement and calculation and EN 12102). Rigid Ø200 ducted product, as per second picture par 4.3. (D) Value that ensures correct operation and eases maintenance if the product is not ducted. Correct operation of the product is nevertheless ensured up to a minimum height of 2,090 m, as long as the accessory grilles are used. (E) Outside the operating temperature range of the heat pump, heating of the water is ensured by the integration. Data collected from a significant number of products. Additional energy data are shown on the Product Sheet (Attachment A) that is an integral part of this manual. Products which do not have the label and data sheet required for boiler/solar power configurations pursuant to regulation 812/2013 may not be used in such installations. IPX4 8

MANUALS