Views
3 years ago

Aures Slim Multi - UK Manual

  • Text
  • Appliance
  • Electrical
  • Heating
  • Installation
  • Circuit
  • Heater
  • Outlet
  • Element
  • Inlet
  • Breaker
  • Aures
  • Slim
  • Manual

TECHNICAL

TECHNICAL CHARACTERISTICS For the technical specifications, refer to the nameplate (the nameplate is located on the right side of the water heater). Product Information Power (kW) 9.5 Voltage 220-240V Phases Mono Installation Hidden Installation Constructions Close Outlet Model Refer to name plate Frequency 50/60hz Amper 39,6 Water Protection IP24 Pipe Connection 1/2" BSP Minimu, Water Flow 2.1L/Min Qelec (kWh) 2,191 max water pressure (bar) 8 bar Load Profile XS Lwa (db) 15db wh 39% Rated Volume (lt) 400cc Weight 2400 gr Dimensions 304 mm x 178 mm x 98 mm The power consumption data in the table and the other information given in the Product Data Sheet (Enclosure A to this manual) are defined in relation to EU Directives 812/2013 and 814/2013. The products without the label and the data sheet for water heaters and solar devices, stipulated in regulation 812/2013, are not intended to be used in such assemblies. Products equipped with a regulator knob have the thermostat positioned in the

AURES SLIM MULTI INSTALLATION INSTRUCTIONS The appliance must be installed and commissioned by a qualified technician in accordance with established regulations and local health and safety regulations.. 1. Open the four screws located on the top and bottom of the device and remove the cover from base. 2. Fix the base horizontally against a wall or side of cabinet, ground wire must be connected to the unit, the inlet and outlet water pipes are on the down/bottom side of the unit. Use 4 mounting screws provided. N G L 3. Use the supplied water filter and PRD on the inlet water pipe line (see attached separate diagram Page 9). 4. Connect the incoming water line (cold only) to the inlet water pipe on the bottom left side and the outgoing water line to the outlet water pipe on the bottom right side. Open the mains cock of water supply and check there is no water leakage from the unit. 5. Before performing any operations, disconnect the appliance from the electricity mains using the external switch then connect the power to cable to the appliance. The appliance must be earthed and the earth cable (show with a letter in the drawing) is fixed to the terminal marked by the symbol . 6. Turn on the unit and check that it is operating as required. 7. Reconnect the cover to the base with 4 screws. 8. It is required that a Ground Fault Circuit Interrupter/Earth Leakage Circuit Breaker be incorporated in the circuit. 9. Make sure to install in the right way the pressure relief valve (supplied with the product) before Inlet pipe. 10. It is required to install a flow control restrictor (AERATOR) at the sink or shower. 5

MANUALS