Views
3 years ago

Andris Lux Eco - UK Manual

  • Text
  • Valve
  • Appliance
  • Discharge
  • Heater
  • Electrical
  • Tundish
  • Fitted
  • Thermal
  • Circulation
  • Heating
  • Andris
  • Manual

Description of water

Description of water heater 4 1) Hot water outlet (1/2” male BSP) 2) Temperature and pressure relief valve (30 litre only) 3) Cold water inlet (1/2” male BSP) 4) Control cover 5) Regulation Keyboard 6) Heating Led 5 2 4 5 6 1 3 Over-sink (10/15 OR) 5 1 3 4 1 3 Over-sink (30) 6 Under-sink (10/15 UR) TECHNICAL SPECIFICATIONS For the technical specifications, refer to the nameplate (the nameplate is located next to the water intake/outlet pipes). 6 8

The power consumption data in the table and the other information given in the Product Data Sheet (Enclosure A to this manual) are defined in relation to EU Directives 812/2013 and 814/2013. Products equipped with regulator knobs have the thermostat positioned in the setting condition at its set position shown in the Data Sheet (Enclosure A), used by the manufacturer to declare the appliance's energy class. This appliance is conforming with the international electrical safety standards IEC 60335-1 and IEC 60335-2-21. The CE marking of the appliances attests its conformity to the following EC Directives, of which it satisfies the essential requisites: - LVD Low Voltage Directive: EN 60335-1, EN 60335-2-21, EN 60529, EN 62233, EN 50106. - EMC Electro-Magnetic Compatibility: EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3. - RoHS2 Risk of Hazardous Substances: EN 50581. - ErP Energy related Products: EN 50440. - EN 12897:2006 Water Regulations and Byelaws These regulations and byelaws ensure a good supply of wholesome water, and that only approved materials, pipes and fittings are used to convey water. Building Regulations These are a statutory document and take priority over all other regulations and recommendations. The installation of an unvented hot water system of over 15 litres is classified as a “Controlled Service” and Regulation G3 applies. To meet the requirements of the regulation, installation of an unvented system should be undertaken by a “competent installer”. All installations of unvented hot water storage systems having a capacity of more than 15 litres should be notified to the relevant Local Authority by means of building notice or by the submission of full plans. It is important to note that it is a criminal offence to install an unvented hot water storage system over 15 litres without notifying the Local Authority. Delivery The products are supplied with the following: Unvented water heater (with factory-fitted T&P model 30L) Wall bracket Pressure relief valve set at 6 bar Dielectric junctions Tundish (model 30L only) Expansion Vessel (model 30L only) Check Valve (model 30L only) Pressure reducing Valve (model 30L only) x1 x1 x1 x2 x1 x1 x1 x1 9

MANUALS