Views
3 years ago

Andris Lux - UK Manual

  • Text
  • Valve
  • Appliance
  • Discharge
  • Heater
  • Electrical
  • Thermal
  • Tundish
  • Fitted
  • Circulation
  • Thermostat
  • Andris
  • Manual

Description of water

Description of water heater 4 1) Hot water outlet (1/2” male BSP) 2) Temperature and pressure relief valve (30 litre only) 3) Cold water inlet (1/2” male BSP) 4) Control cover 5) Regulation knob 6) Heating neon 5 2 4 5 6 1 3 Over-sink (NEW EUROPRISMA 10/15 OR) 5 1 3 4 TECHNICAL SPECIFICATIONS For the technical specifications, refer to the nameplate (the nameplate is located next to the water intake/outlet pipes). 8 6 1 3 Over-sink (NEW EUROPRISMA 30) Product information 10 6,6 15 7,4 Refer to the nameplate 30 12,8 Oversink Undersink Oversink Undersink Oversink 2,442 2,691 2,462 2,675 2,775 XXS S 15 dB 35,5% 32,9% 35,3% 33,0% 32,1% - - 17 3.5bar 6bar Under-sink (NEW EUROPRISMA10/15 UR) 10 15 30 - - - 0.75 kWh/day - - - 30 minutes 17 23 23 43 3.5bar 3.5bar 3.5bar 3.5bar 6bar 6bar 6bar 6bar 6

The power consumption data in the table and the other information given in the Product Data Sheet (Enclosure A to this manual) are defined in relation to EU Directives 812/2013 and 814/2013. Products equipped with regulator knobs have the thermostat positioned in the setting condition at its set position shown in the Data Sheet (Enclosure A), used by the manufacturer to declare the appliance's energy class. This appliance is conforming with the international electrical safety standards IEC 60335-1 and IEC 60335-2-21. The CE marking of the appliances attests its conformity to the following EC Directives, of which it satisfies the essential requisites: - LVD Low Voltage Directive: EN 60335-1, EN 60335-2-21, EN 60529, EN 62233, EN 50106. - EMC Electro-Magnetic Compatibility: EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3. - RoHS2 Risk of Hazardous Substances: EN 50581. - ErP Energy related Products: EN 50440. - EN 12897:2006 User instructions PLEASE KEEP THIS BOOKLET FOR FUTURE REFERENCE The heater is insulated to a high standard therefore it may be left on all the time. The temperature of the water may be adjusted by turning the knob on the front of the heater, allow half an hour for the temperature to stabilise between settings. Maximum temperature is achieved with the knob turned fully clockwise. The mark on the regulation knob indicates an setting and corresponds to a water temperature of 55 - 60°C. In hard water areas we recommended a max. 60°C. The neon light shows when the heating element is working, under control of the thermostat. If in doubt ring Ariston Thermo UK Ltd. Technical department 03332407777 Customer service department 03332408777. Note: The water heater does not have an “off” or “low” setting. Water Regulations and Byelaws These regulations and byelaws ensure a good supply of wholesome water, and that only approved materials, pipes and fittings are used to convey water. Building Regulations These are a statutory document and take priority over all other regulations and recommendations. The installation of an unvented hot water system of over 15 litres is classified as a “Controlled Service” and Regulation G3 applies. To meet the requirements of the regulation, installation of an unvented system should be undertaken by a “competent installer”. All installations of unvented hot water storage systems having a capacity of more than 15 litres should be notified to the relevant Local Authority by means of building notice 9

MANUALS